OEEA

How to Use the OEEA automatic watch winder

The OEEA automatic watch winder is designed to keep your valuable timepieces wound and ready to wear.

Here's how to use it:
1. Plug in the power cord of the watch winder and turn it on.

2. Open the door of the watch winder to access the watch holders. Each holder can accommodate one watch.

3. Place your watch on the holder so that it fits snugly and securely. Make sure the watch is centered and that the crown is facing up.

4. Set the rotation mode of the watch winder. You can choose from clockwise, counter-clockwise, or bi-directional rotation, depending on the requirements of your watch.

5. Set the number of daily turns per day. This will vary depending on the specific watch model. Consult the watch's manual or manufacturer for the recommended setting.

6. Close the door of the watch winder and let it run for the desired duration. The OEEA automatic watch winder is programmed to stop automatically at the end of each cycle.

7. When you are ready to wear the watch, simply open the door of the watch winder and remove the watch. It should be fully wound and ready to use.

Note: The watch winder should be placed on a flat, stable surface to ensure proper operation. - To ensure optimal performance, we recommend that you clean your watch winder periodically with a soft, dry cloth. With these simple steps, you can keep your automatic watches wound and in good condition with the OEEA automatic watch winder.

Maintenance Note:
1.If it is used in humid weather, please do not open the cover, so that the winding device is placed in contact with the humid air outside.
2.When there is dust on the box surface, please use the included OEEA wiper to wipe off the surface dust. If there is no OEEA special wiper, use pure cotton soft cloth instead, or mail to OEEA directly. Always use clean water to remove surface dirt, and wipe it with wax water for furniture or purchase special wax water at the same time when buying.
3.When using a dry battery, when the power is insufficient, the red LED light will turn on, and the winding speed will be slow.At this time, please replace the new dry battery quickly, so as not to affect the service life of the winder. , The battery box of the winder will age.
4, Please do not use a similar transformer purchased to prevent the current and voltage from being incompatible with the winder and burn the movement (IC-CPU).
5, As most of the watches' automatic winding boxes are water-polished and high-gloss surfaces, please pay attention to non-slip hands when handling and carrying
6, Please do not place the watch case in a temperature below -15 ° C (-15 ° C below zero).
                
7, Time reference table for the new dry battery used in the automatic watch winder:
name of dry cell one dial two dials three dials four dials five dials
watch capacity single /dual watch dual watch /Four tables three tables /six tables eight tables Ten watches
time (month) (month) (month) (month) ( Month)
Rechargeable No. 1 Battery 6-8 4-6 2-3 1-2 1
non-rechargeable dry cell 1 < /td> 2-3 1-2 1-1.5 0.5-1 0.5-1
© 2001 - 2023 OEEA Coryright